MoTeC M1 Tune User Manual - Manual (Page 34)

User Manual
WORKSHEET COMPONENTS
Printed documents are not controlled Page 33
10.2.5.2 Table Axis Setup
To adjust axis sites and values.
1. Highlight the table and press A , or right click on the table and select Axis »Setup Axis .
► The Axis Setup window displays.
Example Axis Setup window
10.3 Table Interpolation
The M1 Tune Calibrate component has enhanced interpolation functionality to make building
and smoothing tables easier.
Note: Sites marked as tuned are not modified by the interpolate function. See Marking
Sites as Tuned .
Interpolate
(bi-linear)
Takes the corner values from the selected area and interpolates across then
down from there. This is followed by a horizontal interpolate across each row in
the block.
Interpolate
Vertically Takes the top and bottom values and evenly distributes the values in the
middle.
Interpolate
Horizontally
Takes the left and right values and evenly distributes the values in the middle.
Smooth
When a single row is selected, the smooth function performs the smooth from
the values left and right of each point. A block smooth will take each value in
the block and perform a weighted smooth from each surrounding sites. More
weight is given to the vertical and horizontal values, less to the corners.
See Applying Interpolation .