B&K Precision 9150-9153 - Manual - Manual (Page 41)

41
Example: LIST:SAV 1
[SOURce:]LIST:RCL
This command can recall the list file saved before from the register.
Command syntax: [SOURce:]LIST:SAV
Parameter: 1~8
Example: LIST:SAV 1
[SOURce:]LIST:UNIT
This command sets the unit for the list width in either seconds (SECOND) or milliseconds (MSECOND).
Command syntax: [SOURce:]LIST:UNIT
Parameter: SECOND or MSECOND
Example: LIST:UNIT SECOND
Measurement commands
Note: All measurement commands have units in Volts (V), Ampere (A), or Watts (W). Decimal fractions are
allowed.
MEASure[:SCALar]:VOLTage[:DC]?
This command queries the input voltage of the power supply.
Command syntax: MEASure[:SCALar]:VOLTage[:DC]?
Parameter: None
Return parameter:
Return parameter unit: V
Example: MEAS:VOLT?
MEASure[:SCALar]:CURRent[:DC]?
This command queries the input current of the power supply.
Command syntax: MEASure[:SCALar]:CURRent[:DC]?
Parameter: None
Return parameter:
Return parameter unit: A
Example: MEAS:CURR?
MEASure[:SCALar]:POWer[:DC]?
This command queries the input power of the power supply.
Command syntax: MEASure[:SCALar]:POWer?
Parameter: None
Return parameter:
Return parameter unit: W
Example: MEAS:POW?
MEASure[:SCALar]:DVM[:DC]?
This command queries the voltage reading of the digital volt meter.
Command syntax: MEASure[:SCALar]:DVM?
Parameter: None
Return parameter:
Return parameter unit: V
Example: MEAS:DVM?
SENSe:RESistance:RANGe
This command sets the range of the milliohm meter.
LOW: 0.01W resistance range
MIDDLE: 0.1W resistance range