Autel Autolink AL609 - Manual (Page 34)

32
 Use the UP/DOWN scroll button to select a module and press
the OK button.
5.1 Read Codes
 Reading Codes can be done with the key on engine off (KOEO)
or with the key on engine running (KOER).
 Stored Codes are also known as “hard codes”, which are fault
codes, or trouble codes that have been stored in the vehicle
computer memory because the faults have reoccurred for more
than a specified amount of key-cycles. These codes will cause
the control module to illuminate the malfunction indicator light
(MIL) when emission-related fault occurs.
 Pending Codes are also referred to as “maturing codes” or
“continuous monitor codes”. They indicate problems that the
control module has detected during the current or last driving
cycle but are not considered serious yet. Pending Codes will not
turn on the MIL. If the fault does not occur within a certain
number of warm-up cycles, the code clears from the memory.
 Permanent Codes are DTCs that are "confirmed" and are
retained in the non-volatile memory of the computer until the
appropriate monitor for each DTC has determined that the
malfunction is no longer present and is not commanding the
MIL on. Permanent DTC shall be stored in the non-volatile
memory and may not be erased by any diagnostic services or by
disconnecting power to the ECU.
1) Use the UP/DOWN scroll button to select Read Codes from
Diagnostic Menu and press the OK button. (Figure 5.3)