Autel Autolink AL609 - Manual (Page 15)

13
Just follow the steps below to turn on the scan tool:
1) Connect the OBD II Cable to the scan tool.
2) Find DLC on the vehicle.
 A plastic DLC cover may be found for some vehicles and you
need to remove it before plugging the OBDII cable.
3) Plug the OBD II cable to the vehicle‟s DLC.
4) Power up the scan tool, and wait for the Main Screen to appear.
(Figure 3.1)
Figure 3.1
3.6 System Setup
The System Setup function allows you to adjust default settings and
view the information about the scan tool.
1) Language: Selects the desired language.
2) Unit of measure: Sets the unit of measure to English or Metric.
3) Beep Set: Turns on/off beep.
4) Key Test: Checks if the keyboard is working properly.
5) LCD Test: Checks if the LCD display is in good condition.
6) About: Provides information of the scan tool.
 Settings will remain until change to the existing settings is
made.