Atec Agilent-8480 Series - Manual (Page 9)

Power Linearity
Table 7
Power Temperature (25 ºC ±5 C) Temperature (0 to 55 ºC)
100 pW to 10 mW ±3 % ±7 %
(-70 dBm to +10 dBm)
10 mW to 100 mW ±4.5 % ±10 %
(+10 dBm to +20 dBm)
E-Series CW Power Sensor Specifications
Wide Dynamic Range CW Sensors: 100 pW to 100 mW (-70 dBm to +20 dBm).
Table 6
Model Frequency Range Maximum SWR Maximum Power Connector Type
E4412A 10 MHz – 18 GHz *10 MHz to 30 MHz: 1.12 200 mW (+23 dBm) Type-N (m)
30 MHz to 2 Ghz:1.15
2 GHz to 6 Ghz:1.17
6 GHz to 11 Ghz:1.2
11 GHz to 18 Ghz:1.27
E4413A 50 MHz – 26.5 GHz 50 MHz to 100 MHz: 1.21 200 mW (+23 dBm) APC-3.5mm (m)
100 MHz to 8 Ghz:1.19
8 GHz to 18 Ghz:1.21
18 GHz to 26.5 Ghz:1.26
9
Figure 1 : Relative Mode Power Measurement Linearity with EPM series
power meter/E-series CW power sensor at 25°C±5°C (typical)
* applies to sensors with serial prefix US 3848 or greater
Power Level Used as Reference (dBm)
Power Level Being Measured (dBm)
+20
+10
+6
-20
-35
-70
-70 -35 -20 -10 +10 +20
±4%
+3%
±1%
A
B
E-series Power Sensor Specifications
The E-series of power sensors have their Calibration Factors stored in EEPROM and operate over a wide dynamic range.
They are designed for use with the EPM series of power meters and two classes of sensors are available:
• CW power sensors (E4412A and E4413A).
• Average power sensors (E9300 sensors).