Atec Agilent-E8802A - Manual (Page 16)

12
Table 11. Test Port and Receiver Input Levels (Continued)
Description Specification Supplemental Information
Receiver Noise Floor
a
300 kHz to 25 MHz
c
10 Hz IF Bandwidth ≤
-130 dBm
1 kHz IF Bandwidth ≤ -110 dBm
25 MHz to 3 GHz
c
10 Hz IF Bandwidth ≤
-133 dBm
1 kHz IF Bandwidth ≤ -113 dBm
6 GHz to 9 GHz
10 Hz IF Bandwidth ≤
-123 dBm
1 kHz IF Bandwidth ≤ -103 dBm
Crosstalk
Between test ports 1 and 2, with
short circuits at both ports
300 kHz to 1 MHz <-120 dB
1 MHz to 25 MHz <-125 dB
25 MHz to 3 GHz <-126 dB
3 GHz to 6 GHz <-117 dB
6 GHz to 9 GHz <-106 dB
Maximum Receiver Input Level (A, B, R)
300 kHz to 6 GHz -6 dBm, typical
6 GHz to 9 GHz -9 dBm, typical
Reference Input Level (R)
d
300 kHz to 9 GHz -10 to -35 dBm, typical
Maximum Coupler Input Level (Opt 014)
300 kHz to 9 GHz +33 dBm, typical
a Total average (RMS) noise power calculated as the mean value of a linear magnitude trace expressed in dBm.
b May be limited to -90 dBm at particular frequencies below 750 MHz due to spurious receiver residuals.
c May be limited to -105 dBm at particular frequencies below 750 MHz due to spurious receiver residuals.
d Input level to maintain phase lock.