Atec Agilent-8510C - Manual (Page 20)

20
The factory selected addresses are the following:
8510C network analyzer 16
Source #1 19
Source #2 18
Test set 20
Plotter 05
Printer 01
Disc drive 00
Pass-through address 17
Pass-through address: Instruments connected to the
8510C system bus may be accessed via the pass-through
address.
Transfer formats:
Binary (internal 48 bit floating point complex format)
ASCII
32/64 bit IEEE 754 floating point format
Form 5 (for transfer to PC’s)
Interface function codes:
SH1, AH1, T6, TE0, L4, LE0, SR1, RL1, PPO, DC1, DT0,
CO, E1
General characteristics
Rear panel connectors
Sweep in: Input for 0 to 10 V sweep voltage from
compatible sweep oscillator.
Stop sweep: Input and output for stop sweep signal from
compatible sweep oscillator.
10 MHz in: Input for external 10 MHz reference.
Input level: –10 dBm to +20 dBm, typical
Input frequency accuracy: ±0.005% (50 ppm)
20 MHz out: Output of internal 20 MHz
reference oscillator.
Frequency accuracy: ±0.01%, typical
Analog ±10V: Settable output voltage used for auxiliary
voltage domain measurements, or analog output for ana-
log recorders.
Range: –9.995 to +10.000 volts
Linearity: ±0.1%, typical
Resolution: 4.88 mV, nominal
Output impedance: 1k
Ω
External trigger: TTL input to trigger acquisition of
single data point. Delay is included to equalize the single
path delay from the test port. Data is taken on negative-
going TTL pulse.
Pulse repetition period: 1 msec minimum with no
averaging. If averaging, add (200 µs x averaging factor).
Pulse width: 1 µs minimum.
Environmental
Operating conditions: Temperature: 5 ˚C to 40 ˚C
Non-operating conditions: Temperature: –40 ˚C
to +75 ˚C
Power
47.5 to 66 Hz: 100, 120, 200, 240 Vac, ±10%
8510C: 460 VA, maximum
Test sets: 145 VA, maximum
8510XF millimeter-subsystem: 500 VA, maximum
Weight
8510C: Net, 42 kg (92 lb); shipping, 52 kg (114 lb)
8511A/B: Net, 15 kg (33 lb); shipping, 18 kg (40 lb)
8514B: Net, 17 kg (38 lb); shipping, 20 kg (45 lb)
8515A: Net, 19 kg (41 lb); shipping, 22 kg (48 lb)
8517B: Net, 15.5 kg (34.2 lb); shipping, 18.7 kg (41.2 lb)
85105A: Net, 20.4 kg (45 lb); shipping, 24.5 kg (54 lb)
85104A series modules (each): Net, 6 kg (23 lb);
shipping 6.8 kg (15 lb)
8510XF controller: Net, 20.4 kg (45 lb); shipping,
24.5 kg (54 lb)
8510XF test heads (each): Net, 11.34 kg (25 lb);
shipping, 13.6 kg (30 lb)
Dimensions
TOP
SIDE REAR
50.8 cm (20 in) 42.4 cm (16.7 in)
13.3 cm (5.25 in)
44.5 cm (17.45 in)
(Allow 10 cm, 4 inches
clearance at rear panel
for interconnect cables)