Atec Agilent-8510C - Manual (Page 10)

10
Agilent 8510XF system performance
E7350A-005
(45 MHz to 110 GHz)
The following specifications describe the system performance of the 8510XF system in the
E7350A-005 configuration, from 0.045 GHz to 110 GHz. The following system configuration was used to gener-
ate the specifications:
Test set: E7352A-005, millimeter controller and two test heads, 45 MHz to 110 GHz
RF sources: 83621B and 83651B synthesized sweepers (one each)
Calibration kit: 85059A 1.0 mm precision calibration/verification kit
Calibration techniques: SOLT to 50 GHz, and offset-shorts from 50 to 110 GHz
Dynamic range (for transmission measurements)
Frequency range (GHz)
0.045 - 2
2 - 18 18 - 40 40 - 50 50 - 75 75 - 85 85 - 100 100 - 110
Maximum power (in)
measured at port 2 0 dBm 0 dBm +10 dBm +10 dBm 0 dBm 0 dBm 0 dBm 0 dBm
Reference power (out)
at port 1 (nominal) 0 dBm 0 dBm –12 dBm –12 dBm –7 dBm –12 dBm –12 dBm –12 dBm
Minimum power (in)
measured at port 2 –74 dBm –104 dBm –84 dBm –84 dBm –75 dBm –70 dBm –70 dBm –70 dBm
Receiver dynamic range 74 dB 104 dB 94 dB 94 dB 75 dB 70 dB 70 dB 70 dB
System dynamic range 74 dB 104 dB 72 dB 72 dB 68 dB 58 dB 58 dB 58 dB
Measurement port characteristics
Frequency range (GHz)
RESIDUAL 0.045 - 2 2 - 18 18 - 40 40 - 50 50 - 75 75 - 85 85 - 100 100 - 110
Directivity 30 dB 30 dB 26 dB 24 dB 28 dB 28 dB 26 dB 26 dB
Source match 27 dB 27 dB 23 dB 21 dB 28 dB 28 dB 26 dB 26 dB
Load match 27 dB 27 dB 23 dB 21 dB 28 dB 28 dB 26 dB 26 dB
Reflection tracking ±0.10 dB ±0.10 dB ±0.20 dB ±0.25 dB ±0.30 dB ±0.30 dB ±0.30 dB ±0.30 dB
Transmission tracking ±0.273 dB ±0.273 dB ±0.429 dB ±0.669 dB ±0.322 dB ±0.360 dB ±0.451 dB ±0.451 dB
Frequency range (GHz)
RAW (Typical) 0.045 - 2 2 - 18 18 - 40 40 - 50 50 - 75 75 - 85 85 - 100 100 - 110
Directivity 20 dB 20 dB 15 dB 15 dB 11 dB 11 dB 11 dB 8 dB
Source match 20 dB 20 dB 15 dB 15 dB 11 dB 11 dB 11 dB 10 dB
Load match 11 dB 11 dB 10 dB 10 dB 10 dB 10 dB 9 dB 9 dB