ATAS PC PANEL - Manual (Page 3)

PC System Panel
Anchor Clip
#12 x 1” Wafer
Head Screws
PCA91X
“Z” Closure
Shaped
Neoprene Closure
PCA36X
Shed Ridge Cap
PCA349
Shed Ridge
Starter Cleat
PC System Panel
Anchor Clip
#12 x 1” Wafer
Head Screws
ATA-Guard* PCA91X
“Z” Closure
PCA980
Counterflashing
PCA500
Headwall
Trim
Appropriate
Anchor
Fasteners
PC System Panel
Anchor Clip
#12 x 1” Wafer
Head Screws
PCA91X
“Z” Closure
PCA30X/PCA31X
Ridge/Hip Cap
Neoprene Closure
Hip & Ridge Detail
Headwall Detail
Shed Ridge Detail
Hip and ridge applications are handled in the same
manner.
1. Cut “Z” closure to fit between seams and install
in butyl tape.
2. Fasten “Z” closure in bed of sealant at top of
panel. (Use 3 fasteners on 11 1/4” panel,
4 on 12 5/8”, 5 on 15 1/4”)
3. Seal neoprene strips into “Z” closures
4. Snap hip/ridge cap over “Z” closures for it to lock
into place. Pop-rivet one side only to allow for
expansion and contraction.
Notes:
* Trim must be pop-riveted to Z in at least
(1) location.
* Unless otherwise specified, all fasteners for trim
components at 2’-0” o.c.
* Install splice plates at ridge cap joints. Pop rivet
splice to one end of ridge cap to allow for
expansion and contraction.
Install appropriate underlayment to the edge.
1. In standard headwall situation (without venting),
run underlayment from roof plane up headwall.
Install panels up to headwall.
2. Cut “Z” closure to fit between seams and install
in butyl tape.
3. Fasten “Z” closure in bed of sealant at top of
panel. (Use 3 fasteners on 11 1/4” panel,
4 on 12 5/8”, 5 on 15 1/4”)
4. Seal formed neoprene closure into place in
“Z” closure.
5. Install headwall transition over “Z” closure.
6. Apply counterflashing over the headwall trim,
as required.
1. Install metal panel up to the roof peak.
2. Cut “Z” closure to fit between seams and install
in butyl tape.
3. Fasten “Z” closure in bed of sealant at top of
panel. (Use 3 fasteners on 11 1/4” panel,
4 on 12 5/8”, 5 on 15 1/4”)
4. Seal formed neoprene closure into place in
“Z” closure.
5. Fasten starter cleat to face of trim boards at
2” below ridge line.
6. Install shed ridge cap trim over “Z” closure
and starter cleat.