Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 78)

Refer to the back of this manual for Factory Service and Technical Support contact information
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 76 of 122
6.6.4 ADIO Device Configuration (Web Interface Only)
The Supervisor may modify the name of the signal or configure an alarm for the selected item. Some examples
are shown below.
Figure 76–ADIO Device Configuration web interface window (showing 4R/8D device)
NOTE: Alarm configuration/programming for the 4R/8D is to be completed in the digital alarms or custom alarm sections
of the menus; where the alarm condition can be associated with a digital input and mapped to a relay.
Figure 77–Input Name Assignment web interface window (showing 4R/8D device)
Select the device
before accessing
Modify Name button
Once the device
is highlighted,
select Modify Name
Configure Alarms is not an option for the
4R/8D device. See note below.
Select and modify the
name of the desired
channel, then apply
changes or select back