Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 62)

Refer to the back of this manual for Factory Service and Technical Support contact information
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 60 of 122
Calibration
From this pop-up window, the Supervisor can calibrate the selected channel by setting the high
point or low point or both as shown in the following example:
Figure 46–Analog Inputs calibration example
Tap to Cancel or proceed through the screens in the example above. Apply or Discard the
calibration information as desired.
NOTE: a more detailed method of procedure can be found by visiting the Alpha
website at www.alpha.ca . Look under the Support menu item!