Configuration and control, Installing and starting the smx control program, Installing the program – Extron Electronics SMX System Setup Guide User Manual
Page 38: Installing and starting the smx, Control program, Perform this reset (see
SMX System MultiMatrix Switcher • Control and Configuration
32
Configuration and
Control
This section describes alternative methods of control for the SMX
through the SMX Control Program or accessing HTML pages and
includes:
•
Installing and Starting the SMX Control Program
•
•
Using the Web Pages to Configure the SMX
Installing and Starting the SMX Control Program
The SMX can be configured and operated via the Windows-based
SMX Control Program. This program is contained on the Extron
Software Products DVD (included with the SMX). Install and run this
program on a PC running Windows and connected to either of the
SMX serial ports or the Ethernet port. See
b
and
d
, on
connection information. It cannot be run from the DVD drive.
NOTE: For full details on operating the program, refer to the
SMX User Guide.
Installing the Program
1.
Insert the DVD into the drive. The DVD self starts.
TIP: If the DVD does not self start, run Launch.exe from the
DVD.
The Extron Software DVD window appears.
Figure 23.
Extron Software DVD Window