Extron Electronics SMX System Setup Guide - Manual (Page 24)

18 SMX System MultiMatrix Switcher • Front Panel Operation
Setting the Front Panel Locks (Executive Modes)
The SMX has three levels of front panel security lock.
Lock mode 0 — The front panel is completely unlocked and all basic
and advanced features are available.
Lock mode 1 (Executive mode) — All changes are locked from the
front panel (except for View mode and setting Lock mode 2).
Lock mode 2 (Advanced Executive mode) — Basic functions are
unlocked. Advanced features are locked and can be viewed only
(default mode).
NOTE: The SMX is shipped from the factory in Lock mode 2.
Basic features consist of making ties, saving and recalling presets,
setting input audio gain and attenuation, and changing lock modes.
Advanced features consist of setting video and audio output mutes,
setting audio output volume, setting RGB delay (VGA, RGBHV
boards), and setting the rear panel remote port protocol and baud
rate (see the SMX User Guide to adjust many of these features).
Selecting Lock Mode 2 or Toggling Between Mode 2
and Mode 0
Press and hold the Preset, View, and Esc buttons
at the same time for 2 seconds to switch
between lock mode 0 and 2.
The Preset, View, and Esc buttons flash green
twice to indicate Lock Mode 2 is enabled.
The View and Esc buttons flash green twice to indicate lock mode 0 is
enabled.
Selecting Lock Mode 1 or Toggling Between Mode 2
and Mode 1
Press and hold the View and Esc buttons at the
same time for 2 seconds to switch between lock
mode 0 and 1.
The View and Esc buttons flash green twice to
indicate lock mode 1 is enabled.
The Preset, View, and Esc buttons flash green twice to indicate lock
mode 2 is enabled.
C O N T R O L
ESC VIEW PRESET ENTER
C O N T R O L
ESC VIEW PRESET ENTER