Extron Electronics SMX System Setup Guide - Manual (Page 15)

9 SMX System MultiMatrix Switcher • Front Panel Operation
4. Perform one of the following:
•
To mute outputs, press and hold lit or unlit output buttons for
2 seconds.
•
To unmute outputs, press and hold flashing output buttons for
2 seconds.
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
OUTPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Figure 12. Unmuted Outputs 2, 5, and 8 and Muted Outputs 6, 9,
10, and 16 — an Example
NOTE: For video, only RGB is muted. Sync is not muted.
For RGBHV systems, only the R, G, and B boards are
muted. The H and V boards remain active. All tied and
untied outputs can be muted.
5. Press the View button. All button lights
turn off.
Removing Ties
1. Press the Esc button to clear any pending changes. The button
flashes once.
2. Press the I/O Plane button that corresponds to the plane address
of the desired I/O board. The Plane button along with Input 1 and
any of its tied Output buttons light.
3. Press the Input button that corresponds to the desired input
source. Only the last selected Input button lights along with any
currently tied outputs.
4. Press lit Output buttons that correspond to the desired output
devices. Selected output buttons and the Enter button flash.
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
OUTPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Figure 13. Input 7 with Tied Output 3, 4, and 9 with Pending
Removal of Output 4 and 9 — an Example
5. Press the Enter button. All button lights turn off.
ENTER
C O N T R O L
PRESET ESC VIEW