Extron Electronics SMX System Setup Guide - Manual (Page 37)

31 SMX System MultiMatrix Switcher • SIS Programming Guide
Command
ASCII Command (host to switcher)
Response (switcher to host)
Additional Description
IP Setup Commands (Continued)
Set verbose mode
E
X3&
CV
}
Vrb
X3&
]
Enable or disable verbose mode or tagged responses, in which additional information is given in query response.
NOTE:
The SMX can send out unsolicited information (such as a notice of a change in input or some other setting). This is a verbose (wordy) relationship between the switcher and a connected device. For a direct RS-232 or RS-422 connection, the SMX is set for verbose mode by default. When the SMX is connected via Ethernet, verbose mode is disabled by default to reduce the amount of communication traffic on the network. If you want to use verbose mode with a switcher connected via Ethernet, you must set this mode to On each time you reconnect to the SMX.
V
iew verbose mode
E
CV
}
X3&
]
Show verbose mode or tagged response status
X3&
.
Reset Commands
Reset switcher
E
ZXXX
}
Zpx
]
Clears all ties and presets, audio gain and volume, and resets unit to factory default.
NOTE:
Excludes IP settings, such as IP address, subnet mask, and gateway address. Does not remove file system.
Absolute system reset
E
ZQQQ
}
Zpq
]
Clears all ties and presets, and resets unit to factory default (mode 5 reset).
NOTE:
Includes resetting IP address to 192.168.254.254 and subnet mask to 255.255.0.0. Firmware version remains the same.
NOTES:
X3&
= V
erbose mode:
0
= neither verbose mode nor tagged response enabled;
1
= verbose enabled, no tagged
responses (default);
2
= tagged responses enabled, verbose mode disabled;
3
= verbose mode and tagged responses
enabled