Extron Electronics PVS 305SA User Guide - Manual (Page 12)

2-3 PVS 305SA Switcher • Installation
PRELIMINAR
Y
Mounting the Switcher
The PVS 305SA switcher and the power supply can be mounted in the Extron
PMK 550 (Pole Mount Kit) that is installed above the projector. The low profile of
the PMK 550 allows it to be installed in tight spaces.
N There are two models of the PMK 550 and each mounts the PoleVault switcher
differently; one directly to the plate, the other using mounting brackets.
If there is a need to mount the PoleVault switcher on the PMK 550, follow the
appropriate method.
Mounting directly onto the plate using screws.
1 . Remove the cover securing screws and slide the two plastic covers away from
the mounting plate (see figure 2-1).
Remove retaining
screws (4) and slide
the covers away.
Figure 2-1 — Remove the PMK 550 covers
2. Invert the mounting plate and the PoleVault switcher (so the top is against
the plate) and attach the PoleVault switcher to the plate with the two supplied
screws (see figure 2-2).
3. Use the supplied hook-and-loop strips to secure the power supply to the
plate.
PoleVault
Switcher
Power
Supply
Figure 2-2 — PVS 305SA and power supply attached to PMK 550 plate