Extron Electronics DXP Series - Manual (Page 57)

Maintenance and Modifications, cont’d
Digital XPoint Matrix Switchers • Maintenance and Modifications 6-6
Creating and Installing Button Labels
Figure 6-6 provides blank button labels. If desired, photocopy them or cut them
out of the manual, write button information in each button area as desired, and put
them in the switcher’s input or output button windows.
Use the following procedure to install new labels in the DXP’s front panel buttons.
1. Make new labels using either the blanks on page 6-7 or the Button-Label
Generator software (see chapter 5, “Matrix Software”). Cut them out.
2. Remove the button from the DXP by grasping the button firmly and pulling it
away from the front panel (figure 6-5).
There are different button models available. Your buttons may appear
different.
TEXT
Separating the two-
piece button here at
the corner.
Pry the two
pieces apart.
Diffuser
Base
Button Label
Clear Lens
Figure 6-5 — Illuminated button label replacement
3. Use a small screwdriver or Extron Tweeker to gently lever the button cap off
of the white backing plate.
4. Insert a button label into the cap and gently but firmly press the cap onto the
white backing plate.
5. Press the button into place in the matrix switcher.