Extron Electronics DXP Series - Manual (Page 24)

3-7 Digital XPoint Matrix Switchers • Operation
Example 2: Add a tie to a set of ties
The following steps show an example in which a new video tie is added to the
current configuration in enter switch mode. Each step shows the front panel
indications that result from your action.
This example assumes that the switcher is in enter switch mode. If the
switcher is in the quick switch mode, output buttons light red rather than
green and the step in which the Enter button is pressed is not necessary.
1 . Press and release the input 5 button (figure 3-10). If the steps in Example 1
have been completed, the output 3, output 4, and output 8 buttons indicate
ties created in Example 1.
INPUTS
1 2 3 4 5 6 7 8
OUTPUTS
1 2 3 4 5 6 7 8
INPUTS
OUTPUTS
I n p u
4
t # 5
_ _ 5 5 _ _ _ 5
1 2 3 5 6 7 8
Press and release the input 5 button.
The button lights green.
1 second
Buttons for selected outputs light green.
The LCD displays the input number,
then the current switch configuration.
See “Viewing the current
configuration” in this chapter.
Figure 3-10 — Select an input
2 . Press and release the output 1 button (figure 3-11).
Press and release the output 1
button. The button blinks green. The Enter button
blinks green to
indicate the need to
confirm the change.
OUTPUTS
1 2 3 4 5 6 7 8
CONTROL
ENTER PRESET
Buttons are green to indicate current ties.
= Blinking Button
Figure 3-11 — Select a new input
3 . Press and release the Enter button (figure 3-12). The input, output, and Enter
buttons return to either unlit or to background illumination. The LCD returns
to the default display. The current configuration is now defined as input 5
tied to output 1, output 3, output 4, and output 8.
Press the Enter button to
confirm the configuration
change.
CONTROL
ENTER PRESET
STATUS
D X P 8 8
E X T RON
The LCD returns to the
default display.
All buttons return to unlit or
background illumination.
Figure 3-12 — Press Enter