Extron Electronics DXP Series - Manual (Page 40)

4-5 Digital XPoint Matrix Switchers • Programmer’s Guide
Command/response table for SIS commands (Cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Direct write of a global preset Esc + X5 P X3 * X2 !… X3 * X2 ! Spr X5 Directly enters a global preset.
Example: Esc +7P5*2!5*3!3*6!4*1! Spr7 Creates preset 7, consisting of
Input (I) 5 tied to Output (O) 2
and 3, I3 to O6, and I4 to O1.
Executive mode
Lock front panel 1x Exe1 Enable executive mode.
Unlock front panel 0x Exe0 Disable executive mode.
Lock status x X6 1 = exec mode on, 0 = exec mode
off.
Resets
Reset global presets Esc ZG Zpg Clear all global presets.
Reset whole switcher Esc ZXXX Zpx Clears all ties, global presets,
background illumination, and
executive mode.
View ties and presets
View video output tie X2 % X3
Example: 7% 02 Output 7 video tied to input 2
video.
View preset configuration X4 VC X3 •(4 (DXP 44) or 8 (DXP 88) total)•Vid
Show preset X4 ’s video
configuration. Show the video
input tied to 4 or 8 sequential
outputs.
Response description: input # (I#) is assigned to output # (O#)•I# assigned to O#+1...I# assigned to O#+7•Vid
Example: 1VC
1 Output:
Response = tied input:
Input 4 tied to output 1
2 3 4 5 6 7 8
4•8•4•6•6•2•0•0•Vid
No tied input
Each position listed in the response corresponds to an output: left = output 1, right= output 8. The number shown in
each position is the number of the input that is tied to the output represented by that position.
Preset 1— Input 4 is tied to outputs 1 and 3, input 8 is tied to output 2, input 6 is tied to outputs 4 and 5, and input 2 is
tied to output 6. No input is tied to outputs 7 and 8.
List individual sync X1 LS X7 1 = sync detected, 0 = no sync.
Input sync information is available by request only. No unsolicited responses
are made.
The switcher always detects if an SDI signal is present. However, due to
the switcher’s input circuit sensitivity, the switcher may report that a signal
is detected when no signal is present at the input.
Information requests
Information request I V X9 X X10
Example: i V8X8 8 inputs and 8 outputs.
Request part number N 68-xxx-xx See appendix A for part #s.
Example: n 60-401-01 DXP 88 SDI part # is 60-401-01.
Query software version Q X8
Example: q 2.00 The version number shown is for
example only.