Extron Electronics DXP Series - Manual (Page 39)

Programmer’s Guide, cont’d
Digital XPoint Matrix Switchers • Programmer’s Guide 4-4
Command/Response Table for SIS commands
Symbol definitions
= Carriage return/line feed
= Carriage return (no line feed)
• = Space
X1
= Input number 01 – 04 (Digital XPoint 44 SDI);
01 – 08 (Digital XPoint 88 SDI)
X2
= Output number 01 – 04 (Digital XPoint 44 SDI);
01 – 08 (Digital XPoint 88 SDI)
X3
= Input number (for tie) 0 – maximum number of inputs (0=disconnected)
Input and output numbers in commands may be entered as either 1-, 2-, or 3-digit numbers. All input
and output numbers are specified as 1-digit numbers in the response.
X4
= Preset number 00 – 16 (0 = current configuration)
X5
= Preset number 01 – 16
X6
= On/off 1 = on;
0 = off
X7
= Sync 1 = sync detected (signal present);
0 = no sync
X8
= Controller software version number to second decimal place
X9 = Total number of inputs
X10 = Total number of outputs
Command/response table for SIS commands
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Create ties
Tie input X3 to output X2 , all X3 * X2 ! Out X2 •In X3 •All Video and audio tie. (DXP does
not support audio.)
Example: 1*3! Out3 •In1•All Tie input 1 all to output 3.
Tie input X3 to output X2 , video X3 * X2 % Out X2 •In X3 •Vid
Example: 7*5% Out5•In7•Vid Tie input 7 video to output 5.
Quick multiple tie Esc +Q X3 * X2 !… X3 * X2 ! Qik
Example: Esc +Q3*4!3*5!3*6! Qik Tie input 3 to outputs 4, 5, and 6.
Tie input to all outputs X3 *! In X3 •All
Example: 5*! In05•All Tie input 5 to all outputs.
• The ! video tie command and the % all tie command can be used interchangeably on the
Digital XPoint models.
• Commands can be made back-to-back with no spaces. Example: 1*1!02*02!003*003!...
• The quick multiple tie and tie input to all outputs commands activate all switches
simultaneously.
Global presets
Save current configuration as preset X5 , Spr X5 Command character is a comma.
Example: 9, Spr09 Save current ties as preset 9.
Recall a preset X5
.
Rpr X5 Command character is a period.
Example: 5
.
Rpr05 Recall preset 5, which becomes
the current configuration.