Extron Electronics DXP Series - Manual (Page 29)

Operation, cont’d
Digital XPoint Matrix Switchers • Operation 3-12
Background illumination
The buttons on the front panel can be set to provide amber background
illumination at all times or the background illumination can be turned off. To
toggle the background illumination on or off, press and hold the Input 1 and
Input 2 buttons for approximately two seconds.
Executive mode (front panel security lockout)
The executive mode limits the operation of the Digital
XPoint switcher from the front panel. When the switcher
is in executive mode, all of the front panel functions are
disabled except for the ability to toggle background
illumination on and off. See “Background illumination”
above.
To toggle executive mode on or off, press and hold the Enter and Preset buttons for
approximately two seconds. When the switcher enters executive mode, the LCD
displays X-Mode Enabled for approximately 8 seconds. The LCD also displays
X-Mode Enabled when a front panel button is pressed while the switcher is in
executive mode. When the switcher exits executive mode, the LCD displays
X-Mode Disabled. Release the Enter and Preset buttons. To toggle the executive
mode state again, press and hold the Enter and Preset buttons again.
System reset to factory defaults
To reset the switcher to the factory default settings, press and hold the Enter button
on the front panel while you plug in the switcher. Continue to hold the Enter
button until the power up sequence is completed (all front panel buttons cycle on
and off from left to right lit green, right to left lit red, and left to right lit amber).
System reset clears all ties and presets, background illumination, and the executive
mode to the factory defaults.
STATUS
E n a b l e d
X - Mo d e