GE Industrial Solutions 6KCV301DNET - Manual (Page 30)

GEI-100435A
——————
Interface card DeviceNet
——————
30
1 8 More than 2 group 2 object have been created
1 9 Maximum number of allocatable group 3 identifiers already allo-
cated
2 0 Group specified in open messaging connection is invalid
2 1 Invalid service code received in received ucmm request message
2 2 Duplicate MacId check response has been received
2 3 Duplicate MacId check request has been received
2 4 Cannot send open cnxn-based request since a request is outstanding
2 5 A connection within the client is not available
2 6 Timer Id not correct
2 7 expected_packet_rate not supported (is greater than maximum
allowed)
2 8 No more Timer available
2 9 watchdog_timeout_action not correct
3 0 Watchdog time-out occured
3 1 UCMM time-out occured
3 2 Explicit time-out occured
3 3 Attempt to deallocate a CAN channel not allocated
3 4 No more CAN channel available
3 5 No more CAN channel available for transmission
3 6 CAN Interrupt register error
3 7 CAN is still in hardware reset
3 8 CAN status register error
3 9 Error on allocation
4 0 BusOff detected
4 1 Error on the-allocation
4 2 Too much data
4 3 Parameter object data type not correct
4 4 Connection path not correct
4 5 I/O length not correct
DnetStUser Meaning
C o d e
0
No error exists
1 No resource available
2 Duplicate MacId Check error
3 Illegal transmission
4 Illegal reception
5 Illegal action
6 Time-out error
7 Parameter error
8 DeviceNet is not enabled
9 DeviceNet module is not present or not ok
1 0 Hardware problem
0FFFFH General error