GE Industrial Solutions AF-60 LP Micro Drive - Manual (Page 7)

2.1.3. Symbols
Symbols used in this Programming Guide.
NB!
Indicates something to be noted by the reader.
Indicates a general warning.
Indicates a high-voltage warning.
* Indicates default setting
2.1.4. Abbreviations and Standards
Abbreviations: Terms: SI-units: I-P units:
Acceleration m/s 2 ft/s 2
AWG American wire gauge
Auto Tune Automatic Motor Tuning
rC Celsius
Current A Amp
I
LIM
Current limit
Energy J = N·m ft-lb, Btu
rF Fahrenheit
FC Frequency Converter
Frequency Hz Hz
kHz Kilohertz
LCP Local Control Panel
mA Milliampere
ms Millisecond
min Minute
MCT Motion Control Tool
M-TYPE Motor Type Dependent
Nm Newton Metres in-lbs
I M,N Nominal motor current
f M,N Nominal motor frequency
P M,N Nominal motor power
U M,N Nominal motor voltage
par. Parameter
PELV Protective Extra Low Voltage
Power W Btu/hr, hp
Pressure Pa = N/m² psi, psf, ft of water
I INV Rated Inverter Output Current
RPM Revolutions Per Minute
SR Size Related
Temperature ˚C ˚F
Time s s,hr
T LIM Torque limit
Voltage V V
Table 2.2: Abbreviation and Standards table .
AF-60 LP™ Micro Drive Programming Guide
6
2