beautypg.com

Draw-Tite 58503 FIFTH WHEEL MOUNTING RAILS ACCESSORY User Manual

Draw-Tite For the car

background image

© 2012 Cequent Performance Products, Inc.

Sheet 1 of 1

58503IN

07/23/2012

Rev. A

IMPORTANT NOTES FOR THIS INSTALLATION

1.

Observe caution and note below and double check all areas prior to drilling. Refer to Fig. 1 for spacer placement in
assembly.

2.

Where

the truck bed’s angled corrugation interferes with the mounting rail drill hole, widen hole through truck bed with

a 1 3/8” diameter drill.

3.

Instead of using the rail kit’s horseshoe spacer, drop service kit tube spacer (1) through widened hole in truck bed to
prevent crushing bed sill when

torqueing 2” carriage bolt.

4.

Make sure spacer falls directly between the frame bracket and mounting rail and is fastened tightly with the carriage
bolt.

5.

Repeat steps 2-4 for other places of interference. Some installations may require an additional service kit.

INSTALLATION INSTRUCTIONS 58503 SERVICE KIT

For Installation Assistance or Technical Help, Call 1-888-521-0510

58503 Service Kit Components QTY.
1. Spacers (4)

NOTE: ACTUAL BOLTING POSITIONS ON BED SILL MAY VARY DEPENDING ON PARTICULAR VEHICLE (SEE
VEHICLE’S INSTALLATION GUIDE FOR VEHICLE SPECIFIC APPLICATIONS). CARRIAGE BOLT AND
MOUNTING RAIL INCLUDED IN RAIL KIT AND ARE SHOWN IN FIG. 1 ONLY FOR INSTALLATION REFERENCE.

Fig. 1

CAUTION!

Read 30035 Installation Guide (pages 2-3) before starting installation. Failure to do so could
result in significant vehicle damage!

CAUTION:

Check for obstructions before drilling. Failure to do so could result in damaged fuel or

brake lines, structural members, etc. TOWING PRODUCTS does its best to communicate

tow vehicle manufacturer changes; however, it is ultimately the responsibility of the

installer to prevent damage due to installation.

Use provided tube spacer and

2” carriage

bolt included in rail kit to attach through

bed sill

Use conventional

installation assembly for

center mounting holes

This manual is related to the following products: