OSRAM PrevaLED Core Z2 - Manual (Page 23)

23
3
7
5
2
4
8
6
ASSEMBLY IN A REFERENCE LUMINAIRE
To demonstrate the light engine concept and the design
of a luminaire, the following pages will lead you through
an exemplary assembly of a reference luminaire, using
the 2000-lm PrevaLED
® light engine.
The fi rst picture shows the different components
of the complete system:
• Housing (acts as a heat sink)
• Refl ector
• Cover
• Decorative ring
• Mounting ring
• Main connection wire
• Cable kit
• Thermal interface material
• Light engine
As a fi rst step, the thermal interface material has to be
applied within the light fi xture housing and/or the heat
sink.
6.1. Preparation
After applying the thermal interface material, the LED
module has to be attached to the surface. For mounting
instructions and screw selection, please see the instruc-
tion in
chapter 5.4. LED module attachment .
To ease the centering of the LED module, small plastic
sticks or pins can be inserted into the screw holes in the
heat sink to guide the LED module into the right place.
After centering, these guiding pins can be removed and
replaced by the screws.
6. Assembly in a reference luminaire
1