Spectrometer configuration screen, Connect spectroscopic accessories, External triggering options – Ocean Optics HR2000CG-UV-NIR User Manual
Page 17
Installing the HR2000
Spectrometer Configuration Screen
The Spectrometer Configuration screen prompts you to configure specific channel-level spectrometer information,
if necessary.
Select Spectrometer | Configure | Wavelength Calibration tab from the menu and set system parameters. If
you have connected your spectrometer to the PC’s USB port, OOIBase32 pre-fills the coefficients for the HR2000
from information on a memory chip in the spectrometer. Otherwise, you must manually type the coefficients as
they are printed on the Wavelength Calibration Data Sheet that accompanied your spectrometer. Verify that the
calibration coefficients match the coefficients from the Wavelength Calibration Data Sheet. If necessary, modify
these values using the USB Programmer utility. Additionally, ensure that you select both the Master and Channel
Enabled boxes.
In the A/D Interface tab, enter the same values as in the Configure Hardware dialog box. OOIBase32 stores this
information for future use once you close the program.
Note: For information on using the HR2000 with the OOIPS2000 Operating Software for the handheld PC, visit
.
Connect Spectroscopic Accessories
To find operating instructions for HR2000-compatible products (such as light sources, sampling chambers, and
probes), consult the Software and Technical Resources CD or the Ocean Optics web site at:
External Triggering Options
You can trigger the HR2000 using a variety of External Triggering Options through the 20-pin Accessory
Connector on the spectrometer.
Consult the External Triggering Options document located at the following address:
The External Triggering PDF contains instructions on configuring External Triggering Options for the HR2000.
Note: Only the external software triggering option is available when using a handheld PC.
HR2000 High-Resolution Fiber Optic Spectrometer
13