Factory Direct Hardware Toto ABA990X#01FCP - Manual (Page 38)

38
■ Cleaning the strainer in the water drain lug
Debris in the plumbing will collect in the strainer, so after connecting the plumbing and running water through it and after
the trial operations, please be sure to clean the strainer.
Caution
If the product won't be delivered to the customer for a long time or if it will not be used for a
long time, please remove the water from the function module and shut off the power. (See
Instruction Manual.)
❈ After the water has run out of the fill-tub outlet, the water inside the function module will still be quite hot. Please wait
until the equipment cools to avoid scalds or burns.
❈ Hot and cold water will run out of the water drain lug, so please place a bucket or other container underneath the
function module to catch the water.
➀ Close the hot/cold water valves in the plumbing connected to the connection ports.
❈ The location of the shut-off valves will vary with the installation site.
Hot water
connection
Hot water valve Cold water valve
Cold water
connection
Close Close
➁ Set the on the controller to ON and wait around 20 seconds.
❈ Please do this with the On/Off button set to ON.
➂ After confirming that no water is flowing out of the fill-tub outlet, turn the On/Off button to OFF.
• If the water continues flowing, please set the On/Off button to OFF again and start from step (1).
Sometimes, the controller will display error code 572.
• This is a notice that the water has been shut off. After resetting the error (See Page 37), set the On/Off
button to OFF and proceed to step (4).