Factory Direct Hardware Toto ABA990X#01FCP - Manual (Page 22)

22
6-3 Controller stand installation
(1) Marking the pilot hole, drilling the hole and installing the plug
➀ Cut the conduit sheath for the wires that protrude from the surface of the deck.
➁ Place the base so that the conduit sheath stays in the center and, being careful of the installation direction, mark the
three places where the holes will be that will secure the base
❈ Please be careful of the position of the groove and the front during installation and fix it in place, keeping the
movable range of the remote controller in mind.
° 5
4 °
5
4
Groove
Movable range of remote controller stand
❈
45° to the left and right of the front
Front
Groove in base
Back of base
Drill
Pilot hole
Plug
Pilot hole
➂ Drill the pilot holes the size of the plug where the marks were made.
(Please choose plugs that fit the 4 x 30 Philips head tapping screws.)
➃ Check that the position of the hole is not in a hollow part of the tile
surface. If it is hollow, please fix it in place using an adhesive tapping
anchor.
➄ Place the plug in the pilot hole and pound it in.
➅ To keep water from seeping through, seal the gap between the plug and
the hole.