Factory Direct Hardware Toto ABA990X#01FCP - Manual (Page 17)

17
5-4 Function module installation locations
Please locate the function module in a place where freezing and moisture from indoor water will not be a problem.
Please leave a space of at least 2 ft. (600 mm) in front of the equipment so that inspections or repairs can be made.
Also, please do not locate it on a second-story wall or other place without access.
Please locate the function module in a place that is strong enough to bear its weight and a margin (40 lbs (18 kg)).
Please take the following into consideration when deciding where to place the function module.
- The length of the cables to the equipment (pumps and the like) that will be installed with the bathtub
A 23 ft. (7 m) or 49 ft. (15 m) cable is provided.
- A height which allows the plumbing to be inclined so that the bathtub can be drained more easily when removing the
water.
Within 7m
Within 7m
Please install in a location that will not cause damage if there is water leakage.
If you install in a location that can cause damage please add water protection and appropriate drainage on the floor.
If the tub installation is downstairs the function module should be within 23 ft. (7 m) of the top of the tub (see diagram).
If the tub installation is upstairs the function module should be within 23 ft. (7 m) of the top of the tub (see diagram).
In this case the supplied water pressure should be 29 psi (0.20 MPa) above head pressure.