Installation instructions (continued) – S&B Filters Cold Air Intake Kit - Cotton Filter 75-5050 User Manual
Page 3
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
INSTALLATION INSTRUCTIONS (Continued)
3
P/N: 75-5050 / 75-5050D
25.
Remove the protective covering from
the Clear Lid
(K)
, then install the lid. Secure
using the four 10/24” Screws
(O)
, Sealing
Washers
(N)
, and
two
5/16” Screws
(M)
and
Rubber washers
(L)
. Do not over tighten.
26.
Reconnect the battery. Inspect your
installation, make sure the kit is properly
positioned and all fasteners are secure. The
installation is now complete.
21.
Install the small end of the Silicone
Adapter
(R)
over the throttle body outlet.
Secure using a #56 Hose Clamp
(J)
. Loosely
slide the #60 Hose Clamp
(I)
around the
opposite end.
22.
Remove the MAF sensor from the OE
air box lid using the supplied Torx tool. With
the small rubber OE ring gasket in place,
install the MAF sensor into the Intake Tube
(P)
using the M4 Screws
(S)
.
23.
Install the Intake Tube
(P)
into the
Silicone Adapter
(R)
and then slide the Hump
Adapter
(Q)
over the opposite end. Secure all
the hose clamps at this time.
24.
Install the supplied MAF sensor
extension harness
(Z)
between the MAF
sensor and the OE MAF connector. Use the
supplied wire tie to position the harness away
from any potential hazards.
SEE EXPLODED VIEW ON PAGE 5
ATTENTION:
DO NOT USE THREAD
LOCKER ON THESE SCREWS. VAPORS
CAN CAUSE CRACKING ON LIDS.