S&B Filters Cold Air Intake Kit - Cotton Filter 75-5004 - Manual

6/5/2008
REV-A
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(OVER)
S&B P/N 75-5004
2005-2008
FORD MUSTANG
4.0L V6
5. Unbolt the air box from the inner
fender.
6. Remove the OE intake
assembly from the vehicle.
8. Remove the MAF sensor from the
OE intake.
9. Use the supplied hardware and secure
the MAF to the sensor plate with the rub-
ber washers between MAF and plate.
Secure the plate to the tube, make sure
the MAF sensor is facing the correct way.
13. Use the OE bolt to secure the “L”
bracket to the inner fender.
1. Turn off the ignition and disconnect
the negative battery cable.
3. Loosen the hose clamp at the
throttle body.
4. Disconnect the electrical connection
from the MAF sensor .
7. If the OE grommets came out with
the air box, place them back into the
inner fender.
10. Assemble the air box using the
5/16” hardware.
12. Insert the Air Filter into the air box.
Push the flange of the filter thru the hole
in the air box.
11. Use the supplied hardware to secure
the ”L” bracket to the air box.
Qty Description Qty Description Philips screwdriver
1 Adapter 2 8-32 x 7/16” MAF screw 5/16 nut driver or
1 Air Box 2 #8 Rubber Washer Flat head screwdriver
1 Intake Tube 1 MAF Sensor Plate 3/8 wrench or socket
1 Air Filter 2 10-32 Screw 1/2 wrench & socket
1 Air Box Lid 1 MAF Sensor Gasket 12mm socket
1 CARB Sticker 2 #10 Washer (black) 10mm wrench
1 #8 Hose Clamp 1 10-24x3/4” Screw (black) ratchet
2 #60 Hose Clamp 1 10-24 Nylock Nut socket extension
1 5/8”x1/2” Hose Barb 2 5/16” Acorn Nut
1 5/8” x 2-1/4” long Hose 2 5/16” Bolt
1 1/2”x1/4”npt Hose Barb 2 5/16” Jam Nut
1 1/2” x 26”long Hose 4 Sealing Washer
1 “L” Bracket 4 SS Pan Head Screw
Parts List
787 S. Wanamaker Ave, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
2. Disconnect the PCV line from the
intake tube and from the valve cover.
Required Tools