S&B Filters Cold Air Intake Kit - Cotton Filter 75-5008 - Manual

9/12/2006
REV-B
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
1. With the ignition off, disconnect the
battery. The battery is located in the trunk.
2. Pull up to remove the engine cover.
(Except SRT models)
3. Disconnect the crankcase breather
hose from the OE air box.
4. Disconnect the electrical connection for
the air temperature sensor.
5. Loosen the hose clamp at the throttle
body.
9. Assemble the S&B intake tube and
adapter, also insert both 1/2” rubber
grommets.
6. Unclip the OE air box lid and lift out
the upper air box assembly.
13. Install the intake tube and air box
assembly. Place the air box snout into the
hole in the inner fender then slip the
adapter over the throttle body and secure
all hose clamps.
7. Remove the 10mm bolt that secures
the lower air box assembly.
11. Put the filter in the box. Pull the filter
flange thru the round hole in the box.
8. Remove the lower air box assembly
from the vehicle. 12. Place the #64 hose clamp over the
intake tube then insert the tube into the
filter.
Required Tools
Phillips Screwdriver
Flat Head Screwdriver
10mm Wrench & Socket
7/16 Wrench
(Over)
Parts List
Qty Description Qty Description
1 1/2” x 10” Hose 2 1/2” Grommet
1 3.5” - 3.75” x 2” Adapter 1 1/4” Washer
1 3.75” - 2.75” x 3” Adapter 1 Twisted Bracket
1 Intake Tube
1 Twisted 45*Bracket
1 Air Box 1 1” Rubber Washer
1 Clear Lid 1 1/2” Hose Barb
1 Air Filter 1 1/2” 90* Hose Barb
2 #56 Hose Clamp 4 Sealing Washer
1 #60 Hose Clamp 4 SS Pan Head Screw
1 1/4”-20X3/4” Bolt
787 S. Wanamaker Ave, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
10. Put the small adapter on the air box
snout, secure with a #56 hose clamp.
S&B P/N 75-5008
Applications:
2005-2007 Dodge
Charger, R/T, SRT8, Daytona,
Magnum, R/T 5.7L, 6.1L V8
2005-2007 Chrysler
300C, SRT8 5.7L, 6.1L V8