S&B Filters Cold Air Intake Kit - Cotton Filter 75-5043 User Manual
Installation instructions, Vehicle application, Tools required
1.
With the ignition switched off and the
parking brake set, disconnect the negative
battery cables on both batteries.
INSTALLATION INSTRUCTIONS
Vehicle Application
Year: 2007.5-09
Make: DODGE
Model: RAM 2500/ 3500
Engine: 6.7L TURBO DIESEL
Tools Required
• 10mm Wrench & Socket
• 1/2” Wrench & Socket
• 7/16” Wrench & Socket
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver, Pliers or Channel locks
Notes
Kit may not fit with the following:
• Trucks with Remote Start option
• Aftermarket Parts installed
• Body Lift or Lowering Kit
• Custom Hood
• Intercooler or Turbo upgrades
Before You Start
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not attempt to work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
787 S. Wanamaker, Ontario, CA 91761 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
4.
Loosen the hose clamp at the turbo inlet,
next pinch the spring clamp and slide it up the
steel piping. Then disconnect the silicone
hose from the steel piping. You will reuse
clamp for installation.
7.
Carefully remove both sensors from the
stock air box and set them aside for now.
2.
Disconnect the electrical connection for
the Intake Air Temp. (IAT) Sensor and the
Mass Air Flow (MAF) Sensor then unsnap the
wire loom from the tube. (See the next step
for removal)
5.
Remove the mounting nut on the stock air
box. Save the nut for the installation.
8.
Use the supplied 8-32 SS Screws
(F)
and Sensor Gasket
(E)
, and install the MAF
sensor into Intake Tube
(C)
. Do not over
tighten.
3.
For the MAF sensor, Slide the
red
locking
tab up then depress the black lever while
disengaging the connector. For the IAT
sensor just depress the
grey
lever while
disengaging the connector.
6.
Lift up and out to remove the stock air
box assembly from the vehicle.
P/N: 75-5043 / 75-5043D
SEE EXPLODED VIEW ON PAGE 4
1
Locking Tab
Lever
S&B Filter Maintenance
Cleanable
(KF-1035)
. If the enclosed filter is Red, it came pre-oiled
from the factory. Please visit
amount required after cleaning.
Disposable
(KF-1035D)
. If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil)
. For more info on S&Bʼs disposable
.
9.
Place the Silicone adapter
(B)
and both
#64 Hose Clamps
(A)
onto the Intake tube
(C)
as shown. Tighten the clamp on the intake
tube so that the screw can be accessed for
future tightness checks.