S&B Filters Cold Air Intake Kit - Cotton Filter 75-2514-4 User Manual
Installation instructions
3/17/2009
REV-D
(909) 947
-0015
PHONE • (909) 947-0603 FAX
www.sbfilters.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
(OVER)
S&B Part # 75-2514-4
FORD
F-Series V8-4.6L, 5.4L
(Except Super Duty)
Expedition V8-436L, 5.4L
Navigator V8-5.4L SOHC
* Kit may not fit vehicles with a body
lift installed.
QTY PARTS
LIST QTY PARTS
LIST
1
3” / 3.5”Step Adapter
1
3/4” x 6” Hose
1
3.5”/ 4” Step Adapter
2
1/4”-20 Speed Nut
1
Intake Tube
2
1/4”-20 x 3/4” Bolt
1
Air Filter Shield
2
1/4” Fender Washer
1 Air
Filter
2 Gasket
1
1/2” Grommet
1 Filter Adapter
2
#64 Hose Clamp
4
1/4-20 x 1” Bolt
2
#60 Hose Clamp
4
1/4 Washer
3
#8 Hose Clamp
TOOLS REQUIRED
Screw Driver (flat)
7/16” Socket
10mm Socket
Socket Extension
(Long)
Ratchet
13mm Wrench
1. With the engine turned off, disconnect the
vehicle’s negative battery cable. Loosen the 3
bolts that secure the throttle body dust cover.
3. Disconnect the electrical connection
for the air temperature sensor.
2. Remove the dust cover.
4. (a) On 4.6L Engines: Disconnect both the
air bypass valve line and the crankcase vent
line from the OE air intake tube.
4. (b) On 5.4L Engines: Disconnect both the
idle air control line and the crankcase vent
line from the OE air intake tube.
5. At the throttle body, loosen the hose clamp
on the OE air tube.
7. Pull up to release the OE air intake tube
assembly from the grommets. And remove it
from the vehicle.
6. Disconnect the electrical connection for
the MAF sensor.
8. Unclamp and open the air cleaner to gain
access to the MAF housing.
9. Use a flat head screw driver to pry up the
rubber grommet, turn it side ways and push it
back through the hole.
10. Release the four clips that secure the MAF
sensor housing by pushing with a flat blade
screwdriver. Remove the housing and set the
wiring harness aside for now.
11. Remove the 4 bolts to separate the MAF
from the housing.
12. Assemble the MAF sensor, heat shield
and the filter adapter using the two gaskets
and 1/4-20 x 1” bolts provided.
5.4L Engine shown.