S&B Filters Cold Air Intake Kit - Cotton Filter 75-5023 User Manual
Installation instructions
1.
With the ignition switched off and the
parking brake set, disconnect the negative
battery cable.
INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2004
Make: Ford
Model: F150
Engine:
5.4L
TOOLS REQUIRED
• 8, 10, 13mm Wrench or Socket
• 1/2” Wrench or Socket
• T-20 Security Torx Wrench (Supplied w/ Kit)
• 5/16” Nut Driver or Flat Blade Screwdriver
• Ratchet
S&B FILTER OIL
Your Air Filter P/N: KF-1049 is factory oiled and
ready to use. When serviced it will require:
71g - Main Body
17g - Power Stack (Top)
NOTES
Kit may not fit with the following
Aftermarket Parts Installed:
• Body Lift
• Custom Hood
• Throttle Body Upgrade
• Throttle Body Spacer
BEFORE YOU START
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not attempt to work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
787 S. Wanamaker, Ontario, CA 91761 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
4.
IF EQUIPPED: Disconnect the brake
boost vacuum line from the air box on the
Driverʼs side. Note: ONLY IF EQUIPPED, the
S&B tube
(C)
must be cut at the trim line prior
to installation.
7.
Unclip the wire loom from the OE air box.
2.
Disconnect the crank case vent line from
the passenger side valve cover and air box
and remove.
5.
IF EQUIPPED: Remove the bolt that
secures the OE intake tube assembly to the
engine.
8.
Pull up at the throttle body to remove the
intake assembly from the vehicle.
3.
Disconnect the electrical connection for
the MAF sensor, at the air box on the Driverʼs
side.
6.
Remove the 4 studded bolts that secure
the OE air box to the intake manifold.
9.
IF EQUIPPED: Remove the OE tube
bracket only. Re-install the lower nut on the
mounting stud and tighten.
P/N: 75-5023 / 75-5023D
SEE EXPLODED VIEW ON PAGE 4
1
No Brake Boost Vacuum Line
Notice the factory cap installed.