S&B Filters Cast Aluminum Intake Elbow 76-1010 User Manual

Installation instructions, Vehicle application, Tools required

With the ignition switched off and the

parking brake set, disconnect the negative
battery cables on both batteries.

Installation Instructions

Vehicle Application

Year: 2005-07
Make: Ford
Model: F-Series
Engine: 6.0L V8

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -

www.sbfilters.com

Loosen the hose clamp at the intercooler

lower flange and remove the OE boost tube
from the vehicle along with clamps. Remember
how this is removed because it will have to be
repeated to install the new one.

Remove the 4 bolts that secure the OE

elbow to the intake manifold and remove the
elbow from the vehicle. Be careful not to let
debris fall into the intake manifold.

Optional step, to allow better access to

the elbow. Use a small flat head screwdriver
and pry the clips open and pull up working
your way across to remove the upper fan
shroud.

Remove the other clamp from the OE

boost tube. Clean the two clamps as they will
both be re-used on the lower connection of
the new tube.

P/N: 76-1010 / 76-1010B

SEE EXPLODED VIEW ON PAGE 3

Tools Required

• Ratchet and extensions

• 8mm, 10mm, 7/16” Wrench & Deep Socket

• 3/16” Hex Drive

• Torque Wrench (in.lbs.)

• Teflon tape

Notes

• All required torque specs. are called out in

Inch pounds NOT foot pounds.

• Installation will take approx. 1hr. to

complete.

Before You Start

• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.

Remove the OE (or aftermarket) intake to

gain access to the clamps of the OE boost
tube. Follow the manufactureʼs procedures
for removing the intake.

Loosen the upper hose clamp at the OE

elbow and pry the compression clip out of the
groove.

Apply sealant (Teflon tape) to each

1/8”NPT plugs

(G)

and insert the plugs into

the ports you will not use on the elbow. Use
3/16” Hex drive and torque the plugs to 40
In.lbs.

Place 6mm Washer

(D)

over each of the

M6x30mm Bolts

(F)

and one over the

M6x93mm Bolt

(E)

, next apply a small

amount of the supplied thread locker to each
of the bolts.