S&B Filters Cold Air Intake Kit - Cotton Filter 75-5050 - Manual

1. Be sure engine is cool before starting!
With the ignition switched off and the parking
brake set, disconnect the negative battery
cable.
INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2009-10
Make: Ford / Lincoln
Model: F150,Expedition,
Navigator
Engine: 5.4L
TOOLS REQUIRED
• 10mm, 13mm, 5/16” Wrench or Socket
• Phillips head Screwdriver
• 5/16” Nut Driver or Flat Blade Screwdriver
• Teflon tape
• Ford approved engine coolant (To top off new
coolant reservoir if needed)
NOTES
Kit may not fit with the following
Aftermarket Parts Installed:
• Body Lift
• Custom Hood
• Throttle Body Upgrade
• Throttle Body Spacer
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
4.
Loosen the hose clamp at the air box/
intake tube connection. Then remove the
intake tube assembly from the truck.
7.
Remove the other air box mounting bolt
using 13mm socket. Carefully tip the air box
assembly away from the fender so that
coolant isnʼt spilt.
2.
Loosen the hose clamp at the throttle
body.
5.
Undo the three clips holding the air box
cover to the air box. Remove the air box lid
and air filter from the truck.
8.
Pull the assembly out of the factory
grommets and remove from truck. Note: You
will have to remove the bolt from the rubber
tube to fit through the air box assembly.
3.
Disconnect the MAF sensor by sliding
the red locking pin back, press in the bottom
of the harness and pull out the male
connection.
6.
Using a 13mm socket, remove the rear
air box mounting bolt. Then carefully remove
the coolant overflow tube from the reservoir
and use the mounting bolt as a temporary
plug for the tube.
9.
Remove the mounting insert and rubber
grommet from the OE air box assembly.
P/N: 75-5050 / 75-5050D
SEE EXPLODED VIEW ON PAGE 5
1
S&B FILTER MAINTENANCE
Cleanable (KF-1035) . If the enclosed filter is Red, it came pre-
oiled from the factory. When serviced, apply (87g) of S&B oil to the
main body of the filter and (17g) to the Power Stack (Top).
Disposable (KF-1035D) . If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil) . For more info on S&Bʼs disposable
filter, visit www.sbfilters.com .
BEFORE YOU START
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support
at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the
Parking Brake is set.
Thread Locker Use
We have provided a small tube of thread locker in
your kit. Whenever you see the symbol above on a step
of the instructions apply 1 small drop of the thread locker
to the threads of the screws or bolts. This will keep your
hardware from vibrating loose during rough driving. If the
hardware ever needs to be removed, do so slowly to
avoid having the inserts strip out from the plastic. DO
NOT USE ON LID HARDWARE.