S&B Filters Cold Air Intake Kit - Cotton Filter 75-5068 User Manual
Page 4
Installation Instructions (continued)
P/N: 75-5068 / 75-5068D
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
SEE EXPLODED VIEW ON PAGE 7
4
23.
Remove the MAF sensor and IAT
Sensor from the factory air box by removing
the three factory bolts.
24.
Place MAF sensor and IAT Sensor onto
the S&B intake tube
(X)
using the 8-32 pan
head screws
(U)
and gaskets
(V&W)
.
25.
Remove the swing gate motor
(L)
from
the side of the factory air box using a T-27
torx key.
27.
Mount the swing gate motor onto the
bottom of the S&B intake air box
(I)
using
spacers
(K)
and screws
(M)
and washers
(BB)
.
28.
Construct the S&B Swing Gate Dam to Arm
(N&S)
using the provided hardware
(O,P,&R)
and using the provided
Allen key
(AB
)
. If you desire to have both inlets open in the
air box skip this step.
Warning
: The Dam
(N)
must be
installed during harsh weather including but not limited to
rain, ice, sleet or snow; or engine damage could result.
30.
Note
: Do NOT remove Swing Gate Arm
(S)
after installing it to the motor as this could
damage the snap in feature of the arm. If
removal of Dam
(N)
is desired, remove with Arm
(S)
installed on motor
(L)
.
29.
When placing the swing gate arm
(S)
onto
motor
(L)
please make sure the flat side of the swing
gate arm is placed correctly on the flat side of the
motor shaft. Push down on diverter base all the way
down till it snaps into place.
Warning:
Never operate the vehicle with
the Swing Gate Arm
(S)
removed or a
Active Air Box Error will result & require
the motor to be sent to S&B to be reset.
The Dam (N) can be removed during
good weather conditions.
See #28
above
.
33.
Install S&B intake tube
(X)
into S&B air
box
(I)
by sliding the tube through the tube
seal
(Q)
. This should be a snug fit. A perfect
seal is not required.
32.
Install the hose
(T)
with
(Y)
hose clamps. Next
install coupler
(Z)
and hose clamps
(AA)
onto the
S&B intake tube
(X)
. Remember to only tighten hose
clamps (Y) and (AA) on the tube side.
31.
Install the provided inlets
(G&J)
and tube seal
(Q)
into the S&B air box
(I)
by inserting and
snapping into place. A bit of force and effort may be
necessary to install inlets and seal. Line up each
part with the dot on the box.
26.
A good amount of force may be required to
remove the motor from the factory air box. The motor
shaft may need to be rotated while removing from the
factory butterfly valve in the factory air box. Grab both
the butterfly valve and motor and twist while pulling out.