B&B Electronics EKI-6311GN-EU - Manual - Manual (Page 35)

Page 29
Chapter 4 Advanced Settings
4.1 Advanced Wireless Settings
Open “Advanced Settings” in “Wireless” to make advanced wireless settings.
Figure 16 Advanced Wireless Settings
WMM Support
WMM (Wi-Fi Multimedia) is a subset of 802.11e. It allows wireless communication to define a
priority limit on the basis of data type under AP mode only, thus those time-sensitive data, like
video/audio data, may own a higher priority than common one. To enable WMM, the wireless
client should also support it.
A-MPDU/A-MSDU Aggregation
The data rate of your AP except wireless client mode, could be enhanced greatly with this option
enabled; however, if your wireless clients don’t support A-MPDU/A-MSDU aggregation, it is not
recommended to enable it.
Short GI
Under 802.11n mode, enable it to obtain better data rate if there is no negative compatibility
issue.
RTS Threshold
The EKI-6311GN sends RTS (Request to Send) frames to certain receiving station and
negotiates the sending of a data frame. After receiving an RTS, that STA responds with a CTS
(Clear to Send) frame to acknowledge the right to start transmission. The setting range is 0 to
2346 in byte. Setting it too low may result in poor network performance. Leave it at its default of
2346 is recommended.
Fragmentation Length