B&B Electronics EKI-6311GN-EU - Manual - Manual (Page 22)

16
Chapter 3 Basic Settings
3.1 Factory Default Settings
We’ll elaborate the EKI-6311GN factory default settings. You can re-acquire these parameters by
default. If necessary, please refer to the “Restore Factory Default Settings”.
Table 1 EKI-6311GN Factory Default Settings
Features Factory Default Settings
Username admin
Password password
Wireless Device Name
apXXXXXX (X represents the last 6
digits of Ethernet MAC address)
Operating Mode AP
Data Rate Auto
LAN
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Gateway 0.0.0.0
Primary DNS Server
0.0.0.0
Secondary DNS Server 0.0.0.0
Spanning Tree Enable
802.11 Mode 802.11b/g/n
Channel Number 6
SSID Wireless
Broadcast SSID
Enable
HT Protect Disable
Data Rate Auto
Output Power 100% (Full)
Channel Mode 20MHz
WMM Enabled
RTS Threshold (byte)
2346
Fragmentation Length (byte) 2346
Beacon Interval 100
DTIM Interval 1
Space in Meter 0
Flow Control by AP Disable
Security Open System
Encryption None
Wireless Separation
Disable
Access Control Disable
SNMP
Enable/Disable Enable
Read Community Name
Public
Write Community Name Private
IP Address 0.0.0.0
3.2 System Requirements
Before configuration, please make sure your system meets the following requirements:
A computer coupled with 10/ 100 Base-TX adapter;
Configure the computer with a static IP address of 192.168.1.x, as the default IP address of EKI-