Rainbow Electronics U3742BM - Manual (Page 8)

8
U3742BM
4735A–RKE–11/03
Figure 7. Temperature Compensation of V
RSSI
Figure 8. RSSI Characteristic
If R
Sense
is connected to V
S
, the receiver operates at a lower sensitivity. The reduced
sensitivity is defined by the value of R
Sense
, the maximum sensitivity by the signal-to-
noise ratio of the LNA input. The reduced sensitivity is dependent on the signal strength
at the output of the RSSI amplifier.
Since different RF input networks may exhibit slightly different values for the LNA gain,
the sensitivity values given in the electrical characteristics refer to a specific input
matching. This matching is illustrated in Figure 6 on page 6 and exhibits the best possi-
ble sensitivity.
R
Sense
can be connected to V
S
or GND via a microcontroller. The receiver can be
switched from full sensitivity to reduced sensitivity or vice versa at any time. In polling
mode, the receiver will not wake up if the RF input signal does not exceed the selected
sensitivity. If the receiver is already active, the data stream at pin DATA will disappear
when the input signal is lower than defined by the reduced sensitivity. Instead of the
data stream, the pattern according to Figure 9 on page 9 is issued at pin DATA to indi-
cate that the receiver is still active.
50k
U3742BM
RSSI
180k
47k
V
RSSI_temp_comp.
I
B
min
= 60
V
RSSI
I ~ Ig(V
LNA_IN
)
0.5
0.6
0.7
0.8
0.9
1.0
1.1
1.2
1.3
1.4
1.5
1.6
-110 -100 -90 -80 -70 -60 -50
P
Ref
(dBm)
V
R
SSI
(V)
max
min
-40°C
25°C
105°C