Grain Systems Tanks PNEG-4135A - Manual (Page 46)

Chapter 5: Base Angle Installation
Installing the Base Angle Shims
A section of the base boot plate will rest on top of the base angle, therefore causing the base boot to rest
unevenly on the foundation. To offset this, base angle shims are required to ensure the base boot sets
evenly on the foundation.
What You Should Know
1. Place the required base angle shim around the anchor bolt next to the base angle.
2. Place the base stiffener over the anchor bolt onto the required shim.
3. If needed, add standard shims under the required base angle shim.
NOTE: If more than one additional shim is required, then the shims must be welded together to the
base plate or the base plate must be grouted to provide the proper elevation.
Figure 5-3 Base Angle Shims
A
6 x 9 Base plate (CTS-2121XX or CTS-
2110XX)
E
B-7028 (Required base angle shim for 8 x 10 base
plate)
B
B-7027 (Required base angle shim for 6 x
9 base plate)
F SS-7212 (Standard shim for 8 x 10 base plate)
C
SS-6953 (Standard shim for 6 x 9 base
plate)
G Base angle (B-7025XX or B-7026XX)
D
8 x 10 Base plate (CTS-2109XX or CTS-
2131XX)
46 Pneg-4135A 135 Ft Diameter 40-Series Bin