Grain Systems Tanks PNEG-4135A - Manual (Page 130)

Chapter 7: Roof Assembly
A A-frame rafter assembly C 1/2 x 1-3/4 in. flange bolt (S-10252)
B Center collar (CTR-0347) D 1/2 in. flange nut (S-10253)
Attaching the A-Frame to the Eave Bracket
Assemble the lower portion of the A-frame rafters to the sidewalls.
1. Install flange bolts (B) and flange nuts (D), securing one side on the A-frame assembly.
2. Repeat this procedure for the other side of the A-frame.
3. Tighten to the recommended torque specifications. See Bolt Torque Specifications, page 26 .
Figure 7-41 Attaching the rafter to the eave bracket
A A-frame rafter assembly D 1/2 in. flange nut (S-10253)
B 1/2 x 1-3/4 in. flange bolt (S-10252) E Hole for alignment tool
C Eave bracket (CTR-0550)
After You Finish
Continue to the next A-frame installation until all of the A-frame rafter assemblies are installed. See
About
Temperature Cable Brackets and A-Frame Assemblies, page 83 .
130 Pneg-4135A 135 Ft Diameter 40-Series Bin