Grain Systems Tanks PNEG-4135A - Manual (Page 36)

Chapter 4: Assembling Sidewall Sheets
Table 4-2 Stripe Colors for Special Sidewall Characteristics (cont'd.)
Extra Stripe Colors
Type of Sidewall Stripe Color
Special Galvanized 160 Florescent Red and Fluorescent Pink
NOTE: Stripe colors are located in the middle of each side of the bundle.
Orientation Detail for Top Sidewall Sheets
To avoid the misalignment of the holes, it is necessary to use the correct orientation of the sidewall sheet
during installation.
NOTE: Always assemble the top sidewall sheets with the orientation shown.
Figure 4-1 3–Post top sidewall sheet orientation
A Top of the top sidewall sheet B Bottom of the top sidewall sheet
Caulking Detail for Standard (Non-Laminated) Sheets
To keep out moisture from overlapping the sheets, it is necessary to apply caulk to each sheet prior to
installing.
NOTE: Always assemble the sidewall sheets with the overlap in the same direction.
• Apply a strip of caulk near the outside edge of the outer sheet and between the outer two rows of
bolts (A), then apply a strip of caulk 10 in. (25.4 cm) long along the horizontal seams (B), as shown in
the figure below.
36 Pneg-4135A 135 Ft Diameter 40-Series Bin