Rough Country 909 User Manual

Page 6

12. Remove the bolt in the center of the cross member securing the transmission to the cross member using a 15mm

socket / wrench. Retain the center bolt for reuse.

13. Support the transmission and remove the cross member by removing the 4 bolts on each side using a 15mm socket.

See Photo 7.

14. Lower the cross member away from the frame.
15. Install the new transmission mount as shown in Photo 8 using the factory hardware. Do not tighten at this time.

16. Place the new cross member on the frame and install using supplied 10mm x 80mm bolts in the outside holes and

the 10mm x 35mm on the inside holes. Tighten using a 15mm socket. See Photo 9.

17. Using bracket as a guide, cut a hole using a 1 1/4” hole saw. See Photo 10.

18. Using the bracket as a guide drill the two holes using a 15/32” drill bit. See Photo 11.
19. Insert the supplied flag nuts and secure with the supplied 7/16” x 1 1/4” bolts and flat washers. See Photo 12.

Tighten using a 5/8” socket.

Photo 7

Remove Bolts from Cross Member

Photo 8

Remove Bolts from Cross Member

Photo 9

Remove Bolts from Cross Member

Photo 10

Photo 11

Drill the holes using a 15/32” drill bit

Photo 12

Insert the flag nuts and secure with 7/16” bolts