Rough Country 909 - Manual (Page 12)

11. Locate the hole on the frame as shown in Photo 7.
12. Place the bracket on the frame as shown and align the two holes in the bracket on the passenger side. The Driver
side will align with the large hole. The two small holes are not present on the driver side. Enlarge / Drill the
holes using a 17/32”. See Photo 8. The holes must be aligned prior to drilling!!
13. Insert the supplied flag nuts in the frame as shown in Photo 9. Needle nose pliers will aid in the installation of these
flag nuts.
14. Secure with the supplied 1/2” x 1 1/2” bolts and flat washers. Tighten using 3/4” socket. See Photo 10.
15. Reposition the brake line as shown to prevent damage while drilling. See Photo 11.
16. Measure 4 1/4” from the center of hole and mark. See Photo 12.
Photo 7 Photo 8
Photo 9 Photo 10
Locate the hole in the frame Align holes and enlarge holes
Insert flag nuts in the frame Secure using 1/2” bolts
Photo 11
Unclip and reposition line
Photo 12
Measure 4 1/4” over