Rough Country 909 - Manual (Page 13)

17. Measure up 1 1/4” from the bottom of the frame as shown and mark. See Photo 13.
18. Using bracket as a guide, drill holes using a 17/32” bit. See Photo 14. Use caution when drilling close to fuel or
brake lines!!
19. Drill the marked holes front and rearward of the bracket using a 1 1/4” hole saw. See Photo 15.
20. Photo 16 shows the holes in the frame.
21. Paint may be applied to the holes to prevent rusting
22. Insert the flag nuts in the frame and secure the bracket using the supplied 1/2” x 1 1/2” Bolts and flat washers. See
Photo 17 & 18. Tighten using a 3/4” socket.
23. Reinstall the brake lines in the clips on the frame.
Photo 13 Photo 14
Photo 15 Photo 16
Measure 1 1/4” up from bottom of frame Drill using a 17/32” bit
Drill using a 1 1/4” hole saw Drilled holes shown
Photo 17 Photo 18
Insert flag nuts in the frame Secure using 1/2” x 1 1/2” Bolts