Rough Country 909 - Manual (Page 10)

46. Make sure the body of the vehicle is centered over the axle and adjust the end as needed and install the end on the
frame with the supplied 12mm x 65mm hardware. Do not tighten at this time. See Photo 31.
47. After making sure the body is centered, tighten the jam nut using a 1 1/8” wrench on the track rod end.
48. Tighten the frame end with a 18mm & 19mm wrench and on the axle end with a 15mm socket.
49. Tighten lower arm axle hardware using a 21mm socket /
wrench.
50. Tighten the lower arm frame mount using a 21mm &
22mm socket / wrench.
51. Tighten the upper arm hardware using a 17mm socket /
wrench.
Photo 31
Install on the frame with 12mm x 65mm Bolt