Rough Country 87496 User Manual
Jeep wj dual 2.2 series stabilizer kit
KIT CONTENTS:
1-Center axle bracket
1-Tie rod brackets
2-Stabilizer Cylinders
1-Center Cover Bracket
1—Kit Bag Containing
3—½” x 2½” Bolts
3—½” Nuts
3—½” Washers
2—
⅜” 1 ½” x 2 3/16” U-bolts
1—
⅜” x 2 ½” x 3 1/4” U-bolts
6—
⅜” Flanged Locknuts
3— 1/2” ID x 1 1/2” Sleeves
1— 3/8” IDx 1.40 Sleeve
1— 3/8 x 3 1/2 Bolt
1— 3/8 Nut
1— 3/8 Washer
Thank you for choosing Rough Country for your off road needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure
you have all the needed parts and understand where they go. Also please review the tools needed list and make sure
you have needed tools.
NOTE: THIS STABILIZER IS FOR USE WITH VEHICLES LIFTED 4”. INSTALLING THIS STABILIZER ON A STOCK
UNLIFTED VEHICLE IS NOT RECOMMNENDED.
TOOLS NEEDED:
9/16” Wrench
3/4” Wrench
15mm Wrench
TORQUE SPECS:
⅜”
10 ft/lbs - 15 ft/lbs
½” 40 ft/lbs - 45 ft/lbs
82296
JEEP WJ DUAL 2.2 SERIES STABILIZER KIT