Rough Country 909 - Manual (Page 15)

30. Remove the sway bar bracket from the frame using a 15mm socket. See Photo 24.
31. Install bracket with the supplied 10mm x 90mm bolts and flat washers. Tighten with a 17mm socket. See Photo 25.
32. Install the supplied 2” tall spacer with the supplied 3/8” x 3 1/4” self tapping bolts. See Photo 25.
33. Install the new coil springs. See Photo 26.
34. Swing up the sway bar link and reattach with the factory
hardware. Tighten using a 15mm socket / wrench. See
Photo 27.
35. Install the bushing and sleeves in rear shocks—a liquid
soap may ease installation of bushing into shock eye. In-
stall new rear shocks in the upper mount with the supplied
shock sleeve /washer with the washer on the inside of the
vehicle with the factory hardware. Tighten using a 15mm
socket / wrench. See Photo 28.
36. Install the lower shock brackets with the supplied 12mm x
100mm (approx 4”) bolts, nuts/washers and sleeves from
Bag2 and bushings/sleeve from Bag3. Tighten using a
19mm wrench. See Photo 29. The relocation of the
shock is needed to run wider tires with stock offset wheels.
Without the bracket the shock will rub the tire under travel
given the 3 link design of the Jeep.
Photo 24
Remove the sway bar mount from the frame
Photo 25
Install the bump stop spacers
Install the sway bar spacer
Photo 25
Photo 26
Install the coil springs
Photo 27
Reattach the sway bar with factory hardware
Photo 28
Crush Sleeve
Photo 29
Install Rear Shock in Upper Mount Install Rear Shock Lower Mount Reloc Bracket
Offset Washer